1. REMOVE REAR COIL SPRING LH (for Rear Coil Spring Type)

2. REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY LH (for Pneumatic Cylinder Type)

3. REMOVE PARKING BRAKE ASSEMBLY

4. REMOVE REAR SPEED SENSOR LH

(a) Disconnect the rear speed sensor connector.

(b) Using a hexagon wrench, remove the bolt and the rear speed sensor.

5. REMOVE REAR HUB GREASE CAP LH

(a) Using a screwdriver and hammer, remove the axle hub grease cap. NOTICE: Do not damage the axle hub.

6. REMOVE REAR AXLE SHAFT NUT LH

(a) Remove the cotter pin and adjusting lock cap.

(b) Using a 39 mm socket wrench, remove the axle hub nut.

7. SEPARATE NO. 2 REAR SUSPENSION ARM ASSEMBLY LH

(a) Remove the cotter pin and nut.

(b) Using SST, separate the No. 2 rear suspension arm. SST: 09950-40011 09951-04010 09953-04020 09954-04010 09955-04031 09958-04011 09952-04010 SST: 09955-04090 HINT: Claw A 09955-04090 Claw B 09955-04031

8. REMOVE REAR AXLE ASSEMBLY

(a) Put matchmarks on the No. 1 rear suspension arm and adjust cam.

(b) Remove the 2 bolts and nut.

(c) Using a plastic-faced hammer, tap out the front drive shaft from the rear axle carrier sub-assembly LH.

NOTICE:

Be careful not to damage the drive shaft boot.

9. REMOVE REAR AXLE CARRIER LH

(a) Remove the 4 bolts and axle hub and bearing from the rear axle carrier.

(b) Remove the O-ring from rear axle hob.